Electrical Engineering Fundamentals By Vincent Del Toro Pdf Access

Problem 5 — Op-amp design (15 pts) Design an inverting amplifier with gain -10 using a real op-amp whose open-loop gain Aol(s) ≈ 10^5/(1 + s/2π·10 Hz). a) (6 pts) Choose Rf and Rin values (standard decade resistances) to realize the closed-loop midband gain -10 and justify choice. b) (5 pts) Compute the closed-loop bandwidth approximately using op-amp open-loop dominant pole. c) (4 pts) Discuss one stability concern with using very large feedback capacitances in the feedback network.

Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.) electrical engineering fundamentals by vincent del toro pdf

Part C — Design, analysis & applications (50 pts) Problem 7 — Filter synthesis & Bode (20 pts) Design a second-order Butterworth low-pass filter with cutoff fc = 1 kHz using an active Sallen–Key topology with unity gain buffer. Use standard component values within a factor of two. a) (6 pts) Provide component values (R1, R2, C1, C2) and show normalized component selection for Butterworth (Q=0.707). b) (6 pts) Derive the transfer function H(s) and show the -3 dB cutoff condition. c) (8 pts) Sketch (or describe numerically) magnitude Bode plot points at 10 Hz, 100 Hz, 1 kHz, 10 kHz, and 100 kHz (provide gains in dB). Problem 5 — Op-amp design (15 pts) Design

Problem 9 — Practical measurement & instrumentation (15 pts) You must measure a small AC voltage (peak 20 mV) in presence of large common-mode interference (~10 V) using an instrumentation amplifier built from op-amps. a) (6 pts) Sketch the schematic conceptually (describe stages: input filtering, INA, gain, common-mode rejection). b) (5 pts) Choose an INA gain to get ~2 V full-scale output and compute resistor values or gain-setting component. c) (4 pts) List three practical techniques to maximize CMRR and reduce noise in this measurement. c) (4 pts) Discuss one stability concern with